 |
 |
Windows and doors must be stored undercover avoiding
any water penetration. |
| |
|
|
| Before installation begins, all windows and doors
must have at least one base coat of stain or paint. (This applies
to all edges of sash and frame) |
|
 |
| |
|
|
Windows
|
|
|
| |
|
|
 |
|
Place window in opening on packers at maximum 1200mm
centres. A packer must be placed at each end and under any mullions.
Place packer behind each fixing point (1No. 100mm from top and 1No.
100mm from bottom and at centres no more than 1000mm) on the vertical
frames. Side frames must be straight. |
| |
|
|
|
|
All windows must be level |
| |
|
|
|
|
|
On deadlights the packers must be placed 100mm from
the outside of the frame.
Windows wider than 1800mm and windows with multiple
sashes must have a fixing to the frame head of each sash. Never
fix through the vent slot.
|
| |
|
|
|
|
|
Before the window is firmly fixed ensure the sash
is centred within the frame. |
| |
|
|
| After final fitting and also prior to hand over to
client open and fully reverse the window. Ensure the window reverses
smoothly and locks in the cleaning position. |
|
 |
| |
|
|
 |
|
If foam is used to seal around windows, the frame
must be braced. Also the correct quantity used and the correct temperature
in accordance with manufacturers instructions. |
| |
|
|
| |
|
|
Doors
|
|
|
| |
|
|
 |
|
Ensure the surface the door is to be placed upon
is level and flat. |
| |
|
|
|
|
Place packer behind fixing points above top hinge,
below bottom hinge and in the centre of the doorframe. If an extra
fixing is required, this should be placed above the middle hinge.
Place packer behind fixing points, 100mm from top, 100mm from bottom
and above or below the lock keep.
N.B. Doorjambs must be straight and plumb.
|
| |
|
|
| Before the door is firmly fixed ensure that the margins
are even down hinge and locking side. |
|
 |
| |
|
|
| To the head of the doors the margin must be even
or slightly smaller at locking side. |
|
 |
| |
|
|
| After final fixing and prior to hand over to the
client ensure that doors open and close freely, locks, handles, espagnollette,
stays and shootbolts are in good working order. |
|
 |
| |
|
|
| For correct fitting of french door handle
please refer to separate fitting instructions. |
| |
|
|
 |
|
If foam is used to seal around doors, the frame must
be braced. Also the correct quantity used and the correct temperature
in accordance with manufacturers instructions. |
| |
|
|
| We reserve the right to void our guarantee
if the products are not fitted and maintained in accordance with Lyssand's
instructions. |
